GRACO EcoQuip 2 EQm
GRACO EcoQuip 2 EQm

Only Registered Users are able to view pricing.

Mobile Vapor Abrasive Blast Equipment
Compact, portable blast equipment fits in bed of pickup truck.
Compact, fully portable entry-level unit

The built-in hand truck with over-sized wheels makes the EQm easy to move around the jobsite. Don’t let the size fool you, this compact blaster is capable of handling any type of project, from cleaning to surface preparation.

Fits in the bed of most standard pickup trucks
blast pressure ranging from 30-175 PSI
Oversized wheels for easy portability
Pot size of 3.5 cubic ft – holds approximately (8) 55 lb bags of media

Additional information

About Vapor Abrasive Blasting

  • Generates less dust – 92% less airborne dust than dry blasting
  • Optimizes air, water and media ratio – resulting in a fine mist with a blast that is powerful, but with less dust
  • Uses less water than traditional water-based wet blasting
  • Designed for years of solid service
  •  
    Maximum Fluid Working Pressure
    12.1 bar, 1.21 MPa
    Operating Temperature
    1.6˚ – 43.3˚ C
    Recommended Compressor Size+
    5.3-17 m^3/min
    Blast Hose Size (supplied)
    31.75 mm ID
    Abrasive Capacity*
    200 kg
    Dry Weight
    168 kg
    Wet Weight*
    408 kg
    Pressure Pot Volume
    184 liters
    Air Inlet Connection†
    – – – – –
    Water Inlet Connection
    19 mm garden hose connection
    * Abrasive capacity and wet weight was found using 80 grit garnet. Using coarser media or less dense media will decrease weight.
    † 2 in. ground boss adapter included in tool box (see Parts section of the EcoQuip 2 manual for more detail).
    Air Supply Hose Minimum ID
    185–600 CFM compressor and less than 100 ft. hose length
    38 mm ID
    Over 600 CFM compressor or greater than 100 ft. hose length
    51 mm ID
    Sound Data**
    Sound Pressure Level
    133 dB(A)
    Sound Power Level
    139 dB(A)
    Instantaneous Sound Pressure Level
    131 dB(C)
    ** All readings were taken at the maximum system blast pressure 150 psi (10.3 bar, 1.03 MPa) from the operator position. The abrasive used was garnet and the substrate was steel. Tested in accordance with ISO 9614-2.
    + See the Nozzle Selection Guide for information on how to properly select the blast nozzle based on compressor pressure and flow output specifications.